[bigmike_123]

I need some professional help about hooking up my alpine 10" DVC (4ohm) sub to a Kenwood KAC-8104D amp. I'm confused because this is the amp I might by however I can't figure out why it has 2 woofer connection terminals. I want to hook my sub using 1 speaker wire at 2 ohms amp load. I see other amps have just one speaker terminal. Can you tell me what the difference is and how would I connect my sub if the amp has 2 seperate terminals. :undecided

Thanks

 

[bigmike_123]

the outputs positives and negatives are internally bridged for an easier connection when hooking up 2 coils

just wire both 4 ohm coils in the enclosure, and have 1 lead form the amp go to it

fyi my RF Power amps are setup the same way[/QUOTE

So if I understand correctly I just have to wire 1 wire +/- to the amp that will be wire to a 2 ohm load and this will give me the full power?

Why do the create mono amps with 2 sets of speaker terminals? Is that so you can hook up each coil on the sub ( like a 2ohm DVC sub) to each terminal?

 

[bigmike_123]

Thanks for your help. Cheers

 

[bigmike_123]

Word

post pics when your done

we loves pics

I have some pictures posted in the picture section thread. Should be the last one. I'd like to hear your comments.

Cheers

 

[bigmike_123]

Thanks man, it sure took along time. But it turned out pretty nice and tight. I can hardly wait to get an amp hooked up to it. I'm itching to hear it. I'm pickin up an Alpine MRP-M500 from a guy tomorrow. So it should be real soon. chow for now.