Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum banner
1 - 4 of 10 Posts

· Registered
2003 trailblazer_lt
9,821 Posts
So if I understand correctly I just have to wire 1 wire +/- to the amp that will be wire to a 2 ohm load and this will give me the full power?
yes....keep in mind you will have to parallel the coils inside the enclosure to get that 2 ohm load

Why do the create mono amps with 2 sets of speaker terminals? Is that so you can hook up each coil on the sub ( like a 2ohm DVC sub) to each terminal?
yup....I use 8 gauge wire for my subs, and it would be tough to cram 2 leads into one terminal
1 - 4 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.