Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum banner
leds
1-10 of 10 Results
  1. The "How-To" and DIY Section
    I'm have all of my bulbs slowly going out one by one in my cluster, stereo, and ac controls (front digital). Does anyone know how many bulbs are in each. I'm planning in replacing with LEDs and not sure how many to order. Thanks in advance. ~ 2003 trailblazer, 4x4, 4.2, non-Bose
  2. Exterior
    Couple Questions Do the main Front Turn signals under the headlights require a mod or resistor if I put 3757 LEDs in them? Will they hyper flash? Also, the brake lights are the only lights that require a different LED bulb, correct? Finally, Is it illegal if I black out the orange side...
  3. Interior
    heres a few things ive done, ive compleatly tinted every window(including the front windsheild) two fosgate amps, 2 15 in subs, owered three inches installed focal interiors, kick panels which give me extra 2 component sets, a few leds here and their.tell me what you think im always upgrading...
  4. TrailBlazer / Envoy Chat
    Hello Forum, so i came across this, http://www.automotivelightstore.com/grillledkit.aspx I have done reverse lights/license plate lights/interior, but nothing that required an LED strip (where the connection is complete through wiring). So my question is: where does this additional loose...
  5. Interior
    I'm thinking of putting green leds to light the interior of my blazer but Im indecisive of going that route or going with just the bright white leds and I'm thinking green because my blazer is green and I painted the calipers neon green what do you guys think? Thanks for any input also what site...
  6. Exterior
    So I recently ordered every bulb possible before ripping apart the dash to be converted to LED's instead of the regular bulbs. I noticed people had been talking about flasher relays and other bulbs causing instances where the fuses could blow. I decided I'd be that person who doesn't take that...
  7. Exterior
    Hello guys, I was wondering if someone could assist me in finding a forum that shows how to replace LEDs for the license plate, I just wanna make sure i'm doing it properly Thanks, Martin
  8. Interior
    Items used: 5mm blue 1600mcd, 90 degree viewing angle, straw hat LEDs 470 ohm 1/4W resistors I didn't find a write up on this particular setup, so figured I'd put one out there in case anyone with a long wheel base truck needs a reference. The rear unit pops out without much effort or...
  9. Interior LEDs

    Interior LEDs
  10. red cluster lights

    red LEDs shown in the factory cluster
1-10 of 10 Results
Top