Search Results for ‘how to’

Hey guys, This is my latest video on How To Flush and Bleed Your Brakes. I used my pickup truck in this video but it applies to any car or truck. Brake fluid absorbs water so after about 3 years you should flush them. While I know of no one who flushes their fluid that often I figured after 14...

http://www.youtube.com/watch?v=JCCSUjHsFgo

http://www.youtube.com/watch?v=IhBebL0JeAs A quick simple explanation of how to change spark plugs in a 2005 or later Chevrolet Trailblazer. You don't need to be super handy to do this, and it will save you money! * The only slightly difficult part is the removing the wire harness to get at...

Well folks, I've got a ton of new trailvoy videos on the way and there's no way that I'll be able to keep up with a separate thread for each one. They will all be posted here. I'm going to try my best to not have the video addys shuffled so that (hopefully) there will be no dead links in this...

Well, after popping a code P0128 a few weeks back, I found the instructions and inspiration to change my thermostat myself last weekend. BIG SHOUT OUTs to : Double D --- http://forums.trailvoy.com/showthread.php?t=54225&highlight=thermostat and rbarrio --...

This How-To will show you how to use the Alltrade Tools Kit 46 Ball Joint/U Joint Service Set to replace your lower ball joints. It is important to use this tool kit because it is the only one that I have found to have the correct pieces. I will only cover the steps on how to press the ball...

This was done originally here: http://forums.trailvoy.com/showthread.php?t=75665&highlight=air+spring+replacement See link for pics. I wanted to make sure people could find it. This was the approach i used following the advice of some trailvoy membes. Please be careful when attempting and...

I started with the passenger side: Here are my new parts. 2 - Cardone CV Shafts; 36mm axle socket (35mm also needed if you're removing OEM shafts); Synthetic packing grease; 2 qts Mobile 1 75r90 (not used for CV chaft change - just for the differential) 1) set your emergency brake and chalk...

I did the search for replacing the rear spring on my envoy. Found a thread but it veered off the subject byt he 8th post or so. I am planning on installing the GF 1085 kit on it with some Bilstein HDs. I had the truck up in the air on saturday but coulndt ge the huevos to start loosing up...

Lots of informative information has been learned from this site. Figured I would contribute. 03 Envoy. 106k. Had Fan clutch replaced once. 2nd Water pump. Started hearing a grinding in the front. Fan and water pump pulley could be moved around by hand. Total time 30 Minutes. Didn't drain...

I searched the site and have not seen a write up on a tie rod replacement. I just ordered the outer tie rod for the passenger side on my TB. It will be here tomorrow so I will take pictures, write up the steps and then post it. Looks like a pretty simple job. I was able to break the bolt on...

GM recomends the fuel filter be replaced every 30,000 miles. NOTE: This procedure is for the 2002-2004 4.2L I6 motor without a tank shield and was done on a Trailblazer (Envoys should be the same. I know the 2004 Envoy has the same part number). **The fuel filter is located directly in front...

Hi everybody.. this is my first post here on trailvoy.com and i gotta say this is the coolest site for owners of GMC Envoy.. I like all the work u guys do and the cars are just AMAZING!! Anyway, I just wanna ask if it's possible to replace the side stripes of the 2002 envoy with those of 2006...

Hi folks, thought I'd write this up as I just did it and I see a few people asking about it. I got most of the pictures form a K&N instruction manual cuz thats what I was doing at the time, I point some things out in them and lay out some better instructions though. What you will need...

Due to the number of PMs I receive on how to replace a stepper motor I figured I may as well post the how-to. Let me know if you have any questions or issues. How to Replace Gauge Cluster Stepper Motor If the needles in your gauge cluster flutter, stick, or stop working you may have a bad...

I had a shot blower resistor pack (no 1,2 or 3 speeds on the blower) so I ordered a replacement unit. It arrived today and I put it in just now. I looked around and did not see a "how to" on it, so maybe this will help some others. Vehicle 2002 Trailblazer LS - no automatic temp controls...