Search Results for ‘bearing’

Hey everybody! Before posting here; I did my due diligence and search around. However, I could not find exactly what I am looking for. 04TB A4WD would have the occasional dinging noise here and there from a detached CV axle and obliterated race + bearing. Finally gave this repair a shot, only...

I replaced my right front wheel hub in 2014 with a Tinkem and it needs to be replaced again there's around 50 k miles on it is this normal? What is the warranty on Tinkem hubs. next Question is it just started making noise how many miles can i drive on it since it's cold this week and next week...

I heard the dreaded wheel bearing buzz, but it did not change pitch when I went around a corner either direction. I thought maybe it was still a wheel bearing, so I found the drivers side to be the culprit. I took out the wheel bearing and it felt fine. I think something in the differential...

After reading several posts on this site, it's apparent the bearing in the front, passenger side axle disconnect has a tendency to go bad for lack of grease. An entire unit is around $500. Has anybody tried to remove the bearing itself and replace it? Sure would be nice to do that instead of...

Hi , I bought a 2002 Trailblazer LT and the front end is making a humming / rubbing noise , I bought the TB and it has studded winter tires on it , which is what I thought the noise was. But its been getting louder and now I notice its loud when I turn right and going straight , but no noise...

I have a 2002 TB LTZ and while I'm driving there is a vibration sound/feeling through the gas pedal. It sounds just as if 4WD is engaged, but it's not. It is very loud when around 30-40 MPH. My Transfer case actuators are working but switching between 2HI and AWD and 4WD sounds no different as...

I would like to confirm that the inner bearing on the driver side needs to be replaced. When I Grab the end of the CV going into it, there is up and down play. Don't know how much if any is normal or if there should be any play at all. The hub on this side was recently replaced, reducing the...

I have a 2006 4x4 and am my front outer pinion bearing burned up and the seal was blowing oil. I didn't have any problem pulling the front axle or yoke off, or the seal. But, I can not get the outer pinion bearing off. I have tried my two bearing pullers but because of the tight space, I can...